Saber 675 Centre ConsolE – New model

STANDARD Specifications

  • Length = 6.75m
  • Beam = 2.50m
  • Fuel tank capacity = 300 litres
  • Weight = approximately 1.4 tonne (including fuel)
  • Material = 5083 grade aluminum, 2 pack painted
  • Deadrise angle = 21 degrees at rear and 45 degrees at bow
  • D-Section Air collar (Foam collar version upgrade available)

Seating

  • Helm seat with dual flip up bolsters with storage below
  • Rear seat (3 – 4 person)
  • Bow seat with storage locker below

Centre Console

  • Large dash suit dual screens (upto 12″)
  • Built in footrest
  • Storage front/rear and under seat
  • Tall windscreen
  • Binnacle engine control base
  • Cup holders & cordless phone charger 

T-top

  • Small sturdy alloy T-top
  • Deck lights to rear
  • Aerials on roof
  • Light bar to front
  • Anchor light
  • Grab handles

Electronics

  • 9″ GPS/Fish-finder standard, upgradable to 12″
  • VHF radio
  • Bluetooth stereo & speakers
  • Cordless phone charger
  • USB power points
  • Twin Batteries & isolator switch
  • Push button switch panel

Engine

  • Offered standard with 175HP
  • Minimum recommended 150HP & maximum 225HP

Other

  • Anchor locker
  • Transducer
  • 4 x Cleats
  • Rod holders x 4

Fender

  • D-section foam (maintenance free) with polyurethane fabric bag (outer skin)
  • Heavy Duty Rubbing strake (1-row standard

TRAILER

  • Custom dual axle trailer to suit
  • 12 months registration

Price

Price = $156,990 in standard specification with 175hp Outboard & galvanized steel trailer, registrations & safety gear

OPTIONS – available extra

  • Electric windlass $4,700
  • Pot winch & Tipper $4,000
  • Rod holders $125 each
  • Roof racks between hand-rails = $500
  • Ski Post (as shown) = $1,200
  • Trim Tabs (zipwake) = $5,000
  • Fresh water shower c/w below deck 80 tank = $3,000
  • Deck wash (Salt water wash down pump & hose) = $2,000
  • Underwater lights (Hella) = $895 pair
  • Extra electronics = $POA
  • Table c/w drinks holders & grab handle behind helm seat = $1,250
  • Tube covers for upper half of fender (selection of colours) =$3,000
  • Seat box c/w lid, cushion & backrest (to front of console) = $1,500
  • Large T-top (as pictured) = +$5,000
  • Custom fabrication = $POA